News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Jack

#1
I would like to remove the original grindstone (Super grind 2000) and be able to change to other stones available. I have easily removed the nut but am not able to budge the washer holding the stone. I have tapped it and also swabbed some rust solution around the edges without results. The stone has been in place since the original purchase of the Tormek years ago.
What is the secret?