News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - larsfarm

#1
Wood Turning / Re: bgm-100/xb-100
January 31, 2010, 10:40:42 AM
Thank you!
#2
Wood Turning / bgm-100/xb-100
January 30, 2010, 09:04:50 PM
What's the difference between bgm-100 and xb-100?
#3
Wood Turning / Re: svs-50 update?
December 07, 2009, 09:50:16 PM
Thank you!
L
#4
Wood Turning / Re: svs-50 update?
December 07, 2009, 07:48:49 PM
How do you know if you have the old or new?
#5
Wood Turning / beginner questions
November 06, 2009, 08:39:27 PM
I just bought the TNT-708 and have a couple of beginners questions.

1) How do you secure a 3/8 spindle gouge in the SVD-185? the v-shaped support is too deep, the knob doesn't reach deep enough to even reach the gouge. My spindle gouge is 3/8" wide but a lot less deep. So the SVD-185 wont hold it.

2) How do you accurately and repeatably mount a rectangular skew chisel in the SVS-50 such that it is exactly perpendicular to the jig, the universal support and the stone? There is nothing to guide a rectangular chisel in the v-shaped holders. There's a V at the top and a V att the bottom and the chisel has a rectangular skew section.
#6
Wood Turning / Re: Which jig for turning tools?
October 18, 2009, 10:05:25 AM
Do you need both or can SVD-185 do everything that SVS-50 can do?