Don't know what the T yellow tube is full of.
Note that in Leonard Lee's book on sharpening he recommends Al. Ox. for HSS steel.
I'm thinking of getting the profiled leather wheel less for burr removal and more for polishing out the machining marks left in some gouges.
Any comments?
Tormek PA-70 is aluminum oxide abrasive in a paste of mineral oil and other stuff. ;D
It will do a fine job of removing mill marks in your flutes, which is a very worthwhile goal.
Ah, thanks Jeff. Good to know.
Excellent info, as always :)
PS, does it work efficiently on the Tormek? Any mileage in fitting the leather wheel to the lathe eg.?
The plastic hub system is designed for low speed operation. I'm not sure I would spin it up much over 150 RPM.
EDITED TO ADD:
Regarding the speed of the process of removing mill marks from a gouge flute.
I would not try to polish the entire flute of a gouge at once. There's no point to it. Just work the section close to the edge each time you sharpen. Perhaps spend a little bit longer than necessary to remove the burr, and the flute will always be polished where it is important.
Thanks Jeff.
And no, I'm not that obsessive ::)
HI,
I use the Flexcut Gold Polishing Compound, you just apply it like a crayon and it does a wonderful job and dosn't make as much of a mess when applying than the tormek compound.
I use the tormek compound as well.
And what's that compound made of Aunsell?
Jeff, can I ask what the Tormek compound particle size in microns is?
(Yep, now definitely getting obsessive ;D )
Ern,
It is a blend of 3 micron, 2 micron and 1 micron. When the 3 micron particles break down, the 2 micron particles take over, and so on. That's why PA-70 has the unique property of a fast cut and a fine finish.
Clever!
So a bit of pressure wouldn't go astray to break down the 3 micron particles.
Pressure is good. ;D
Watch your angle, though. I do lean on the honing wheel, but before you apply pressure, make sure you have the bevel properly aligned.