Hello,
I have a brand new Tormek T-8. After about one hour of use, it suddenly stops. The motor is completely dead and makes no sound at all. After approximately five minutes, it starts working again by itself.
The motor housing is only slightly warm, not hot, and the grinding wheel turns freely by hand when the machine has stopped.
I have sharpened around 20–30 knives and have probably used fairly heavy pressure while grinding.
Is this normal behavior, or could there be a fault with the machine?
Thank you.
Contact support and ask them. They will sort it out.
Not something that should be happening.
Quote from: John_B on July 26, 2026, 10:43:41 PMContact support and ask them. They will sort it out.
Not something that should be happening.
[/quot
Thanks i will do that tomorrow 👍
Rjje,
I agree with John. Support's email address is:
[email protected].
Keep us posted.
Ken
I haven't received a response from Tormek Support yet. I'll wait a couple more days before following up, as it may be due to the holiday season.
But I'll keep you updated if anything happens.
This is definitely not normal. My T8 is very happy to run and run ;)
A bit of patience at this holiday time is a good idea, it is not a massive company so there are probably a few people absent at the moment which will slow down their response but I am sure Tormek will try to get this sorted for you as soon as they are able to.
Danny
This will be the thermal overload. It is designed to pick up any faults and not cause further damage. This is probably a leaky capacitor or fault in the motor. Tormek support will definitely sort you out.
It happened again today after sharpening about 10 knives. I could feel a lot of heat coming from underneath the honing wheel. I removed the wheel and felt the motor, and it was really hot.
So I think you're right John – it's probably the thermal overload protection kicking in.
I'm taking it back to the store where I bought it and will ask for a replacement
Quote from: Rjje on July 30, 2026, 10:50:50 PMI'm taking it back to the store where I bought it and will ask for a replacement
Good idea.
I got a new machine, works perfect :)
Tormek suport 💪💪