I recently purchased new a Tormek SuperGrind 1200 and when I set the grind angle with the anglemaster for a chisel or plane blade it cuts it about 5 degrees out. So I set it for 30 degrees and when I checked the cut blade it is at 35 degrees. I've check the stone diameter and it is 200 mls and I've set the anglemaster to this. I do get the right degree cut when I set the anglemaster to a 175 ml diameter stone. This doesn't make sense to me and I was wondering if others have had this problem and if the angle master is faulty - not sure how, as it is a simple device.
Sorry, George. I just don't have enough experience with the small machine yet to give you a good answer. I'll try to find out.
If adjusting the diameter to 175 gives you accurate results over several tools, stick with that until we come up with a better answer.