Text only | Text with Images

Tormek Community Forum

In the Shop => General Tormek Questions => Topic started by: getsharp on June 17, 2025, 07:20:46 PM

Title: Tormek Angle Calvulator - Constant Value Verification Request
Post by: getsharp on June 17, 2025, 07:20:46 PM
Hello fellow grinders. I'm hoping someone can help me verify two required constant measurements when using angle calculators.

Are these measurements accurate?
Support Bar Offset: 50mm
Case Height: 30mm

Thank you in advance
Case Height
Title: Re: Tormek Angle Calvulator - Constant Value Verification Request
Post by: cbwx34 on June 17, 2025, 10:39:08 PM
Usually use 50 and 29 (for a T-8)

IMG_0003.jpeg
Title: Re: Tormek Angle Calvulator - Constant Value Verification Request
Post by: tgbto on June 18, 2025, 09:23:19 AM
And as mentioned often, measuring to the surface of the wheel eliminates the need for these intermediate measurements and associated errors.

Plus it is not really harder than measuring straight to the right spot on the casing.
Text only | Text with Images