Hello fellow grinders.
Just upgraded to a new T8 Black from a T4 and found that I cannot mount the DF-250 on the correct side. It easily mounts when I flip the wheel with the plastic wall on the outside but when I flip it over to the correct side (grit wall facing out) the bore won't go past the end of the shaft threading.
Checked for burrs on the inside but it feels smooth.
Quote from: Nikos on July 09, 2024, 06:39:52 PMHello fellow grinders.
Just upgraded to a new T8 Black from a T4 and found that I cannot mount the DF-250 on the correct side. It easily mounts when I flip the wheel with the plastic wall on the outside but when I flip it over to the correct side (grit wall facing out) the bore won't go past the end of the shaft threading.
Checked for burrs on the inside but it feels smooth.
Probably need to contact Customer Support (mailto:support@tormek.se) for this one.
I agree. (support@tormek.se)
Ken
Wolfgang replied, just sent him a video of the problem.
Yeah, same here with mine
Quote from: Columbo on July 11, 2024, 01:50:57 AMYeah, same here with mine
Interesting... might be a bad batch.