Hi All,
Edit: The answer looks to be the SVS-38, which I have.
I have a set of Japanese chisels, with short shafts. Currently working with the 1/4" chisel. 35deg grind.
1) The shaft is so short that I can not use the angle gauge, because it runs into the jig. So, I am eye balling it.
2) Due to the short shaft & low angle, I can only use part of the wheel, as the jig "hinge" rubs on the wheel. I figure I can use just the one side, and then flatten the wheel.
Any obvious issues here I am missing?
TIA,
egg
The MB-102 helps greatly and allows you to use the side of the grindstone.