Just bought the new SE-76 for my 2000 unit to replace the older square edge jig. I also bought the micro adjust universal support a few years ago when it first came out. It seems my support doesn't have the threaded hole needed in the end for the stop on the new SE-76. Has the micro adjust universal support changed? Do I need to upgrade the support too, or can I just drill and tap the end of my existing universal support and make the stop fit?
If you want to use the stop, you can drill and tap -- or get a 5/8-inch "doughnut" shaped rare earth magnet. It does almost as secure a job of stopping movement, and is much easier to put on and take off.
Thanks Jeff, I'll give the magnet a try first.