Bought a used unit, it is older doesn't have horizontal bracket. Tool bar is not threaded. Where is the serial number, if there is one.
Rich,
The older units did not have threaded universal supports. I replaced my bar with the newer one (US-105).
Also, you can order the horizontal support holder as a add-on for your machine. P/n XB-100
Finally, I swapped out my drive shaft for the newer one (MSK-250).
Kind regards,
Rich
Rich,
Be sure to register your Tormek with Tormek (on the www.tormek.com website) I don't think your machine has a serial number. No warranty remains, however, once you register you have access to the latest online version of the handbook. I have downloaded this on my ipad and refer to it frequently. The handbook has not changed much over the years.
Ken
Thanks everyone, registered my T2000 [no 3's] and found all kinds of good stuff in support. Making a list of stuff I have to order to get the results I want in the end. Definitly the book... Thanks again.