Text only | Text with Images

Tormek Community Forum

In the Shop => General Tormek Questions => Topic started by: Arthur on March 21, 2021, 07:36:32 PM

Title: Using TORMEK for flat sharpening
Post by: Arthur on March 21, 2021, 07:36:32 PM
TORMEK adaptation for flat sharpening
Title: Re: Using TORMEK for flat sharpening
Post by: sharpening_weasel on March 26, 2021, 01:27:30 AM
Very interesting! What stone is that? How would one go about truing it?
Title: Re: Using TORMEK for flat sharpening
Post by: Arthur on March 28, 2021, 01:12:29 PM
Quote from: sharpening_by_jesse on March 26, 2021, 01:27:30 AM
Very interesting! What stone is that? How would one go about truing it?
In the photos above the stone for MAKITA 9820.
Title: Re: Using TORMEK for flat sharpening
Post by: Arthur on March 28, 2021, 01:22:14 PM
After receiving two sets of MB-100, the possibilities of TORMEK have significantly expanded and I am happy to use my T-4 for flat grinding.
Also after appropriate preparation (organization of the working area), I use any stones for flat grinding.
Title: Re: Using TORMEK for flat sharpening
Post by: micha on March 28, 2021, 06:50:29 PM
What a sophisticated approach!

I would have been concerned about the cascaded MB-100s being not sturdy enough, interesting to hear that you don't have problems with that setup.
Thanks for sharing,

Mike
Text only | Text with Images