Is it possible to thin a knife blade on the Tormek? If it is possible are there any videos on how to properly do it?
Thanks!!
To thin a knife you'd need to grind at a bevel angle that's smaller than what the grinding jigs were designed for. As far as I know.
Though Tormek is not a primary tool for this, I remember a post on bladeforums.com about grinding a knife from a blank with Tormek.
Now and then I grind false edges on Tormek to turn the knife into a double-edged.
So yes, it is possible, but is it practical? I 'd use Tormek for a one-off job, and only if I don't have a belt grinder/sander.
Here is a link illustrating a saber flat grind modified into hollow on T7, check post #7
http://www.australianbladeforums.com/vb4/the-military-connection/21180-1940s-cattarraugus-225q-quartermasters-knife.html?highlight=#post204533