> Folks,
Here is my idea.Because I have a few medical problems I haven't been
able to do it.
Drill a hole through the arm that holds the diamond.Make a small
stop at the end near the tighting thumb screw.A hole will have to be
drilled to fit over the guide bar.Now on the hole you drilled in the
arm,tap and make a very fine thread.Get a bolt or thumb screw for that
thread about 4 in. long.Turn the thumb screw,hold pressure on the arm
and the bit should walk across the stone.Turn it the other way to take
it back.I want half the money when you put this on the market!
Anything Sharp
Ed Weigman
172 Mountain Lake Estates
Hawley PA 18428
570-685-9755