Hello!
I am upgrading my 1200 with a few things, one being a new universal support.
I figured the US-103 was the way to go, but a big Swedish reseller has the US-105 listed as a spare part for the T-3 as well as the T-7.
So my question is: What's the difference between the two?
/pelle, sweden.
The US-105 will fit a 1200, but it will allow a tool in the SE-76 jig to slip off the edge of the grindstone before it hits the stop. You need the US-103 if you are going to use the stop.
Lovely!
Since I already ordered the 105 this was great news. Thank you!
OK!
I got the US-105, but I thought that it was bundled with a horizontal base. So I ordered the BGM-100 to get both a US-105 and the XB-100. However, I got no instructions on how to properly fit the base on my 1200.
Where can I find such instructions?
/pelle, sweden.
You can find them right here:
http://tormek.com/international/en/spare-parts/
Go to the XB-100 listing and the link to the instructions is at the end of the description.
Go figure :)
Thank you!