I have a Tormek Supergrind 2000 and it will work fine on about 5 chisels. After that when I "lean" into it to take out a nick in the chisel the wheel will slow then stop as the motor stalls. The machine has only had light use over the several years I have owned it. I have had the honing wheel off, but there is nothing obvious. Anything I can try?
thx, Dick
Take the honing wheel off and start the machine. Hold some coarse sandpaper (80 - 120 grit) against the drive tire for a few moments. The surface of the drive tire can become glazed, and then it slips on the motor shaft. That should take care of it.
thx Jeff I will give this a try...Dick