News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - crashgtr

#1
Anyone know which jig is best suited for a small 3/8-1/2 Sorby Spindle master gouge?

The only way I can describe it is- This is one that is a hybrid between a roughing gouge and a spindle gouge with a very small bevel and the fluting is very shallow, almost flat but not quite.

Thanks,
Liz ;D
#2
General Tormek Questions / Diamond grading tool
October 10, 2006, 06:16:59 PM
I read the book, saw the videos by Tormek and Jeff at Sharptoolsusa.com but it is still not 100% clear to me how the diamond dressing tool should be setup and used to true up the wheel.

I tried it but ended up with a lot of grooves!!

Does anyone have a couple of pictures or a video that zooms in on the setup up and proper angles to use the diamond tool?

Thanks,
Liz