News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - c5ct

#1
Tormek T-1 and T-2 / Large/tall knives in t2
December 04, 2022, 07:58:43 PM
So has anyone managed to use the t2 on tall blades? I have one knife that's 18" long and about 3" and tapers to around 2 1/4".

Also where can I source a replacement  plastic guide. I may or may not try and modify the one it came with. Haven't received the sharpener yet so not sure.

T4 or 8 is not ideal as I don't feel like messing with water trough etc. I usually use my edgepro with diamond plates for my smaller knives. The t2 looks like a quick and easy way to get a decent edge.
The large knife I would "gasp" run a carbide sharpener down the edge. Don't judge me lol.

Also knife in question in case anyone was wondering.

Sani-Safe S160-18 18" Pizza Knife with Polypropylene Handle https://a.co/d/4NlqPxh