News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - RLGL

#1
Regarding the magnet for a T-4, I 3Dprinted a tab that hangs on the end of the water trough and used super glue to fasten a rare earth magnet in a recess. Quick and dirty way to solve the issue.
#2
General Tormek Questions / FVB
April 30, 2022, 04:04:56 PM
Is there a source in the US for the FVB?
#3

Very interesting!
#4
Quote from: RichColvin on January 10, 2022, 07:30:09 PM
Dave,

That is an M6-1.0, 15mm long, flat-head screw.  You can get one similar to that from McMaster-Carr as p/n 92125A111, though that one has a hex drive.

McMaster-Carr has other options for screws like that one.  At 16 mm long, the options really open up, and there are options for using a flat-head or Phillips screw driver.  Also, consider looking at screws with an "oval" head vs. flat heads.  May be more appropriate for this use.

Rich

Thanks
D
#5
Many years ago I became aware of the Tormek system of sharpening. Since that time I have spent many $$$$ on different methods and tools. The results were okay but I knew that improvement was needed. I received a T4 unit 2 days ago and spent some time getting used to it. I then made an assault on my kitchen knives and was very please with the results. For what $$$ I spent in the past I could have easily saved a bunch by purchasing the unit years ago.

After some use, it became apparent a small modification would be in order. The screw needs to have a screwdriver slot to assist in snugging it during setup. My reason for the request is fat leathery fingers have a difficult time grasping it. I am considering adding one using a Dremel tool.

The only real complaint I have is the nameplate on the front of the machine was pulled off when removing the Angle Master. I can remedy the situation with some glue.