Hello, I'm a new Tormek user and I must say; I am blown away at the ease and speed of the system. The only issue I've been running into is properly aligning my lettercarving chisels that have a double bevel and an allongee shank.
https://www.lie-nielsen.com/nodes/4163/auriou-lettering-chisels
Is there some sort of trick to do this that I'm not finding. I know the manual suggests using the universal support to draw a line on the grindstone and then align to that but I'm hoping that there is something more precise. The problem is any error I have in this technique is accentuated because I have two bevels to do on each chisel. Any thoughts?
https://www.lie-nielsen.com/nodes/4163/auriou-lettering-chisels
Is there some sort of trick to do this that I'm not finding. I know the manual suggests using the universal support to draw a line on the grindstone and then align to that but I'm hoping that there is something more precise. The problem is any error I have in this technique is accentuated because I have two bevels to do on each chisel. Any thoughts?