Apologies if this has already been covered but was wondering if anyone has used this honing wheel in the way set out by Vadim in the knifegrinders video for lower end knives.? IE: setting the edge on a 400 grit CBN wheel. Honing at exact angle on the composite wheel then cleaning up at exact angle on chromium oxide on a leather wheel. If anyone has I would be interested to know what results this gives with Bess scores. From memory Vadim was getting scores of 70 or so as outlined in the appendix to his book. Thanks.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
#123
Knife Sharpening / Aus 10 steel
August 28, 2021, 04:29:53 PM
Was wondering if anyone is familiar with this steel?
If yes, was also wondering what sort of burr it produces? - positive,negative or intermediate?
Thanks.
If yes, was also wondering what sort of burr it produces? - positive,negative or intermediate?
Thanks.