News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - jtriggs

#1
Planer Blade Sharpening / bowed edge on 6" blades
February 28, 2006, 08:39:10 PM
Jeff,
Been working at 6" jointer blades for a couple evenings. I get a great sharp edge but after having problems mounting in the jointer, I see there is a bow to the edge. The middle of the blade is at least 1 mm higher than either end. I retrued the stone and did it again and got the same result.

Is it my method, my jig or what? I can't figure out what would cause such a bow.

HELP! I need straight blades. And soon!
Jon