Print Page - Tormek Knife Jig on thick blades

Title: Tormek Knife Jig on thick blades
Post by: angpanday on October 10, 2016, 01:47:51 AM

I have just learned on my other post that the knife jig of the tormek can only be precise when holding up to 3mm thick blades. Is this correct? My knives are mostly 4.8 mm ( 3/16 ) thick. Do I always have to turn the stop of the knife jig to make the correct angle every time I turn over the knife. Any help is greatly appreciated :-)

Title: Re: Tormek Knife Jig on thick blades
Post by: angpanday on October 10, 2016, 08:21:27 AM

Ok, I had found the solution on this post...

http://forum.tormek.com/index.php?topic=2962.msg16395#msg16395

Tormek Community Forum

In the Shop => Knife Sharpening => Topic started by: angpanday on October 10, 2016, 01:47:51 AM