Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
Quote from: Drilon on May 30, 2024, 11:37:50 AMI purchased one felt wheel in December 2022 and one in March 2023. Price was US$ 75 plus US$ 25 air shipping plus import duties. The wheels arrived two or three weeks after prepayment.
Only use solutions of diamonds in alcohol as water based solutions will change the properties of the felt.
I like these wheels and I get good results!
Regards,
Drilon
Quote from: Stonepecker on Yesterday at 06:25:05 PMHi all - great to be here!
I've got a T4 with an SVS-38 short tool jig.
After a first go at it, I'm wondering how short ist short, and how long is too long. My chisels are about 13cm long. Is that too long? Couldn't find a clear answer in the original handbook, neither here:
https://sharpeninghandbook.info/WW-Chisels-Carving.html
Thanks for some ideas.
Quote from: Swemek on Yesterday at 04:19:26 PMThanks, my frustration was channeled that way. And it does offer repeatability, but 15.5 degrees per side might be 15 degrees.
Quote from: cbwx34 on Yesterday at 02:15:35 PMThanks, my frustration was channeled that way. And it does offer repeatability, but 15.5 degrees per side might be 15 degrees.Quote from: Swemek on Yesterday at 11:14:23 AMNo actually the whole sliding plastic thing with a knob and the spring.
I was so frustrated yesterday so i did some reverse engineering and build the part myself. It works, the only thing missing is the spring.
Of course i have no way to check how reliable it is but i get perfect fit when checking with the old angle meter.
Some pics:
Barbord
Styrbord
Yikes. Yeah I guess that wasn't accidentally left in the box.
Looks like you came up with a good temporary solution. Congrats on the temporary solve!
Quote from: Berghutze on Yesterday at 02:11:21 PMThank you for your answers. Just to be on the safe side: I grind one side of the knife until I have a burr on the other side? Only then do I grind the other side?
Best
Thomas
Quote from: Swemek on Yesterday at 11:14:23 AMNo actually the whole sliding plastic thing with a knob and the spring.
I was so frustrated yesterday so i did some reverse engineering and build the part myself. It works, the only thing missing is the spring.
Of course i have no way to check how reliable it is but i get perfect fit when checking with the old angle meter.
Some pics:
Barbord
Styrbord
Page created in 0.011 seconds with 14 queries.