Print Page - Sharpening a mortising chisel

Title: Sharpening a mortising chisel
Post by: royaltyl on October 05, 2009, 05:12:24 AM

I just bought a T-7 and proceeded to sharpen all my chisels. I ran into a problem with a 1/2" mortising chisel. It would barely fit into the square edge jig, not enough protrusion to get the desired 30 degree angle. Is there a jig recommended for larger mortising chisels. I was able to sharpen my 1/4" and 3/8"; the 3/8" stuck through just enough to get the angle.

Larry

Title: Re: Sharpening a mortising chisel
Post by: ionut on October 09, 2009, 01:33:26 AM

Hi Larry,

I've posted an answer about this on the "General Tormek questions" thread.

Ionut

Tormek Community Forum

In the Shop => Hand Tool Woodworking => Topic started by: royaltyl on October 05, 2009, 05:12:24 AM