News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - pe2dave

Pages1
#1
General Tormek Questions / t-4, slim knives
March 29, 2024, 04:12:20 PM

 :( Helping a neighbour. Tried to sharpen a 10" knife, max 1" depth. Bit of a curve too.
My t4 was scraping the edge of the blade by the time I got to the tip.
Not sure if this was / is possible.
  Gave up in the end and used a t-2 which worked well.

Horses for courses?
#2
General Tormek Questions / Marking chisels for initial insertion into jig
March 19, 2024, 04:49:45 PM
OK, I'm lazy.
I'd like to slip the chisel into the holder, SE-77 Square Edge Jig,
and know it was (near as ...) set for 25 or 30 degrees.
  Yes, it would need checking over the years, but ...
question: How to 'scratch' / mark a chisel against the jig?
Has anyone done this successfully please?
Pages1