Finally got my T7 in.....WOW.....WOW.....😎
Do I need to drain the water from water tank between uses?
Greg
Do I need to drain the water from water tank between uses?
Greg
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Wood Carving / Which jigs?????
February 10, 2016, 07:31:14 PM
Jeff Farris and others,
What jig is best for sharpening 8-10" mallet woodcarving gouges using a T7?
It seems the Tormek is used by far more turners than carvers, wonder why?
Thanks in advance
Greg
What jig is best for sharpening 8-10" mallet woodcarving gouges using a T7?
It seems the Tormek is used by far more turners than carvers, wonder why?
Thanks in advance
Greg
#3
Wood Carving / An interesting Story
January 31, 2016, 03:55:35 AM
This lil story was included in our monthly newsletter from Tannehill Woodcarvers Club near Birmingham, Al.
There were four people, Everybody, Somebody, Anybody and Nobody. There was an important job to get done and Everybody was sure Somebody would do it. Anybody could have done it, but Nobody did it. Somebody got angry with that, because it was Everybody's job. Everybody thought Anybody could do it, but Nobody realized that Everybody couldn't do it. It ended up that Everybody blamed Somebody when Nobody did what Anybody could have.
Greg
There were four people, Everybody, Somebody, Anybody and Nobody. There was an important job to get done and Everybody was sure Somebody would do it. Anybody could have done it, but Nobody did it. Somebody got angry with that, because it was Everybody's job. Everybody thought Anybody could do it, but Nobody realized that Everybody couldn't do it. It ended up that Everybody blamed Somebody when Nobody did what Anybody could have.
Greg
#4
Wood Carving / T4 Run Time
January 30, 2016, 01:34:40 PM
It's my understanding the T4 cannot be ran continuously for more than 30 minutes. For a new user that doesn't seem very long due to the learning curve. What was your experience when you were a new user?
FYI: while corresponding with Affinity Tool Works In February Tormek will have a promotion on the T7 with 10% off. Also found out Tormek does not sell refurbished units any more, not sure whe that went into affect.
Greg
FYI: while corresponding with Affinity Tool Works In February Tormek will have a promotion on the T7 with 10% off. Also found out Tormek does not sell refurbished units any more, not sure whe that went into affect.
Greg
#5
Wood Carving / Probable New Tomek T4 owner
January 25, 2016, 12:05:48 AM
I've got the opportunity to pick up a used T4 with 6-7 different jigs for a very good price. I've seriously thought about making the investment but could never pull the trigger. Being a woodcarver that will be the tools it'll be used with plus the wife's scissors as she is a very good seamstrist along with the kitchen knives. Look forward to being on here and learning from you guys and ladies.
Pages1