Hi, has anyone tried sharpening Morso guillotine blades on a Tormek and how did it go? Presumably you used the Planer Blade jig, do you have any pointers on the process?
Thank you
Thank you
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: Jeff Farris on December 15, 2003, 08:55:09 PM
Planer blade sharpening is perhaps one of the most challenging jobs the TORMEK can do. However, when done properly the results are better than the majority of professional sharpening services throughout the country. Use this forum to discuss the difficulties and share your successes.
Page created in 0.218 seconds with 15 queries.