Quote from: tcsharpen on May 24, 2024, 03:29:56 AMMy KS-123 arrived today. I first set up to sharpen a kitchen knife using the KJ-45 jig with the KS-123. After getting it all adjusted, I then measured the projection and entered the values into Calcapp which said the USB height should be 88.6mm. Measuring this after the angle setter was used yielded 88.7mm. I'd say this is well within specs of my inexpensive digital caliper used to take the measurement.
Even the first setup was quick after having watched the Tormek video.
Great to hear. I have 2 support bars so for knives I will be setting one for honing and one for sharpening. I will use my jig for setting the projection distance on each knife. Going this the new KS-123 won't be used too much unless someone wants a different angle.
I then used the angle setter to set the honing angle to 1 degree greater. Simple, with great results.