Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
Quote from: Ken S on Today at 04:10:04 AMThe standard US-103 support can handle knives with blades up to 200mm (8 inches).
Ken
Quote from: cbwx34 on Yesterday at 02:26:07 AMRich Colvin has a jig he made for using with the SE-77 that you might find helpful...
Quote from: khun on Yesterday at 10:13:19 PMComments under the video about how to use the SP-650 Stone Grader on Tormek's own website appear to disagree.
https://tormek.com/en/products/accessories/sp-650-stone-grader#h-Specsanddetails
"The fine side gives the surface of the stone up to about 1000 grit."
Quote from: Dutchman on May 20, 2024, 07:00:18 PMWhat I wrote in a previous message New angle jig KS-123Dutchman, Thank you for a great review. I have one on order, should have it in a couple weeks.
I had the pleasure of testing the new angle setter KS-123. It is based on ideas from Perra and meets all expectations.
Quote from my conclusion:
It's a wonderful tool, well designed and beautifully realized. I will definitely start using it. So no more 'Dutchman's tables', kenjigs, spreadsheets or apps on smart phones or tablets. End of an era that began on April 14, 2014 with my publication of "Simple adjustment of the grinding angle". It took 10 years, but now it can be even simpler and more accurate.
Attached is my test report in PDF file.
Page created in 0.024 seconds with 14 queries.