Hi All,
I am new to the forum and from the UK.
I purchased a used T2 described as excellent condition but missing knife jig, unfortunately it's damaged and any advice would be welcome. I purchased a new jig(mk2) but the T2 bar that it mounts on has been impact damaged and is not aligned correctly (bent in toward the sharpening wheel). I see from looking inside it is mounted with 2 Allen screws so should be replaceable, can these be purchased? I cannot see them in any spares list.
Alternatively, I could remove and attempt to straighten the arm, but the alignment will be critical I assume so this may be difficult to do precisely. Do Tormek offer a repair service in the UK?
Any help gratefully appreciated.
Thanks
Dean
I am new to the forum and from the UK.
I purchased a used T2 described as excellent condition but missing knife jig, unfortunately it's damaged and any advice would be welcome. I purchased a new jig(mk2) but the T2 bar that it mounts on has been impact damaged and is not aligned correctly (bent in toward the sharpening wheel). I see from looking inside it is mounted with 2 Allen screws so should be replaceable, can these be purchased? I cannot see them in any spares list.
Alternatively, I could remove and attempt to straighten the arm, but the alignment will be critical I assume so this may be difficult to do precisely. Do Tormek offer a repair service in the UK?
Any help gratefully appreciated.
Thanks
Dean