I just bought Glenn Lucas's GL1 negative rake scraper with a french curve (I'm hoping the attachment works so you can see what it looks like). It has a 33 degree angle on both sides of the steel as well as going around the curve on one corner. I can't figure out how to get it smoothly sharpened on my T8. Being 1 3/8" wide, it wont fit in my SVS-50 multi jig for skew chisels, though I doubt that jig would work because of how long the curve extends around one corner of the steel. I tried the SVD-110 Tool Rest, getting it set to the 33 degree angle to the wheel, but when I try to round the corner on that curve it makes a mess of the grind on the steel. This may be all my fault.
Anyway, I was wondering if someone knew of the best jig to use for this type of tool, if one exist.
Thanks for any help
Grey
Anyway, I was wondering if someone knew of the best jig to use for this type of tool, if one exist.
Thanks for any help
Grey