Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
Quote from: RickKrung on Today at 01:52:00 AMQuote from: RichColvin on Yesterday at 09:24:47 PMBoth have legs which are 145mm long. The difference is in the top bar
- US-105 = 305mm
- US-103 = 295mm
As noted, the US-103 is 10mm shorter to accommodate the 200mm grindstone which is 10mm thinner than the 250mm grindstone.
10mm difference in length???
250mm - 200mm = 50mm
Quote from: RichColvin on Yesterday at 09:24:47 PMBoth have legs which are 145mm long. The difference is in the top bar
- US-105 = 305mm
- US-103 = 295mm
As noted, the US-103 is 10mm shorter to accommodate the 200mm grindstone which is 10mm thinner than the 250mm grindstone.
Quote from: tgbto on Yesterday at 08:55:42 AM...
A quick note on a design choise (which I am not sure is wise): the (grey) sliding platform is more or less self-locking inside the (blue) support. One has to flex it a bit by pressing down in the middle so it slides easily, then release it so it locks back in place, and the (red) back thumbscrew is just here to secure it in place and prevent bending. I might have to play with tolerances and/or add a bit of teflon or the like on the outer surfaces in contact with the support so it slides more smoothly but still locks without significant radial play..
...
Page created in 0.012 seconds with 14 queries.