My axe jig does not move freely across tool bar. Tried silicone spray on both???
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / T 2000
July 13, 2021, 11:34:49 PM
I have a older T 2000 [ no serial number ], it does not have a micro adjust tool rest. Want to replace it with the micro adjust rest. Understand the 105 will not fit the older models? I would like to replace it with the extended model. Also want to put on a horizontal base for the same rest. Trying to get it uniform.
#3
Knife Sharpening / Buck Knife
July 02, 2021, 09:09:50 PM
Found my buck knife I purchased years ago. Has anyone sharpened one? I have a T2000 with the standard stone. Would like to get nice polished edge. Do I need a japanese stone?
#4
General Tormek Questions / T 2000
June 24, 2021, 08:14:04 PM
Bought a used unit, it is older doesn't have horizontal bracket. Tool bar is not threaded. Where is the serial number, if there is one.
Pages1