News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Ignatius

#1
Wood Carving / Re: Tormek jigs
January 10, 2011, 03:03:03 PM
Could I get a comment from Jeff Farris?
#2
Wood Carving / Tormek jigs
January 10, 2011, 12:52:14 AM
I am considering trying to set up a Kalamazoo 48" belt grinder to a treadle sewing machine table (as a variable speed motor),   I would like to use the Tormek jigs to guide my woodcarving chisels.  Can anyone think of why this would be problematic?  Do you think this would work?   Ignatius