News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - stevens1310

#1
I appreciate that others have the same issue - makes me not feel so alone... ;)  BUT - a solution would be even better!  Does no one out there have any guidance to offer?
#2
Planer Blade Sharpening / Grinding is stopping too early
September 30, 2014, 12:09:11 AM
So, I finally worked up the courage to try the planer blade jig.  Pretty straightforward set up, so that wasn't too bad.  I did have to lock the left post first and then crank on the right thumb wheel to get 'er lined up with the the stone, but from what I have been able to read I am not the only one doing that...  ;)

My first set of knives worked like a charm.  They are all FAR sharper than the factory new set I ordered while waiting for my jig to arrive.

On the second set, however, I ran into a problem where - try as I might - I could not get the knives to grind down to the angle stop.  I thought that maybe the stone was glazing over and just burnishing the knife edge, so this is what I tried:

1) I re-surfaced the stone with the fine grader.  No joy.
2) I re-surfaced the stone with the coarse grader.  No joy.
3) I re-trued the stone to expose a fresh new face. No joy - either before or after resurfacing.
4) I started completely over, re-setting everything as if I had never started anything.  No joy.

No matter what I try, there is about 1mm or so of daylight showing between the adjustment screw and the jig hard stop.  And no matter how hard or soft I press, and no matter how long I grind (up to 30 minutes or so, at least...) I cannot advance the grind.  The edge of the blade just gets shinier and shinier - as if I am polishing it, but not removing material.  Just to check things I took off the jig and sharpened a chisel and a kitchen knife - those worked just fine.

I am at a complete loss - and I have this half-sharpened set of knives that aren't doing me any good.  Happily, the first set worked nicely!...

I can see in the forum that others have posted similar problems, but I cannot see any answers.  Any help?  Anyone?  Thanks in advance!