News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - Ken S

#701
General Tormek Questions / comment for Jeff Farris
August 05, 2010, 11:47:48 AM
As a very full time grandfather of two pre-schoolers, my shop time is almost non-existant.  I am able to sneak in some computer time early in the morning.  I have been enjoying the training/demonstration videos that Jeff posted on his site and those in the turner's information kit.  Well done, Jeff.  It's easy to be a cheerleader for a fine product.  You went beyond that and provided some very solid, practical user information.  Thanks.

Ken
#702
On page 90 of his sharpening book, Ron Hock states that he suggested a fix for flattening the backs of chisels and planes with the Tormek, and that it may already be available.  Would you please describe this.
Thanks.