I have a set of manual hedge clippers that are not cutting in the about the first half of the cutting action. Today on closer inspection, I found the main problem is a set issue. The blades are gapping for about that first half of the blades. Tightening the tension bolt helped the situation minutely. The outer end works well. I have cleaned off the crud from the inside of the blades and the pivot.
For scissors, I have a scissors press. It uses two pins set inline. Another pin, with a rotatable eccentric cam on it, is set in an offset position. The blade set is thus "sprung" into the blade. However, hedge clippers are much heavier duty. To make something similar, the press would have to be quite large.
Has anyone used the arbor press style of scissors press? Does anyone have a good idea to place set in manual hedge clippers?