News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - rustic

#1
Hi thanks for all the help I had thought about adding another locking screw to the free USB arm but the metal thickness seemed to light.  The new design base seems the option to go for. Thanks.
#2
Hi so when having the USB on the horizontal base there is movement laterally even when the clamp screw is tight the photos show this better, I am thinking of using another nut to secure the USB better see second photo for position. |And thanks for your reply.
#3
Hi I am sure this question has been asked many many times but I will ask again. Can anyone tell me the thread size for the adjusting nut for the support arm. When Googled it comes up as ACME and I know the bar size is 12mm but no further info can I find. I am trying to take the slack out of the support arm by adding a second nut on the base.