I just bought a Supergrind 2000 that is in serious need of an overhaul.
I would like to remove the motor without cutting any wires. In order to do that it appears that I need to take the motor apart.
If you've done that, please offer any suggestions on how you did it.
Thanks.
Gary
Welcome to the forum, Gary.
Your best bet is to contact support (support@tormek.se). The support people are very experienced and hands on.
Keep us posted.
Ken
>Your best bet is to contact support
Good suggestion. Here is the response I got:
"No you do not have to take the motor apart.
On the inside of the housing you have a cover over the main switch.
This cover can be removed. Underneath you have the wires connected to the main switch with cable shoes.
Just remove them and the connection point for the earth protection..
Then just tap out the shaft that holds the motor and then its loose from the housing."
Perfect. It only took a few minutes to remove the switch. The hardest part was undoing the strain relief.
Gary
Gary,
As we say in English, "See, I told you so!"
Good job.
Keep us posted.
Ken