Quote from: Haldor on February 23, 2018, 05:47:30 PM
is there anyone with a good idea of a jig for such axes(//)
Tormek has an ax jig, the SVA-170... seen HERE (https://www.tormek.com/usa/en/grinding-jigs/sva-170-axe-jig/) ... for axes.
Or are you looking for something else?
sva 170 is for normal axes with about 10-20 cm length of ax head.These axes on the picture are 20-40cm long. So the 170 jig comes for the stone, so I do not get the right angle on the edge.
Quote from: Haldor on February 23, 2018, 06:09:10 PM
sva 170 is for normal axes with about 10-20 cm length of ax head.These axes on the picture are 20-40cm long. So the 170 jig comes for the stone, so I do not get the right angle on the edge.
Ah... cool.
Only thing I can think of (I'm not an ax sharpener though) is Herman's "Knife Rest" jig... might work for what you're looking for. Here's the thread...
https://forum.tormek.com/index.php?topic=1592
... and a video on how it works...
https://youtu.be/AcWAkQmoU8c
...if this doesn't work, I'm sure an actual "ax sharpener" will be along to help out. ;)
You might also look at this thread for some ideas...
https://forum.tormek.com/index.php?topic=3448
... about 1/2 way down the first page, there's a post where Jan uses a clamp instead of the ax jig. (Might spark some ideas).
Hope that helps. :)