Im still really new to this and Im a little confused when it comes to sharpeing the curved portion of a knife. Ive seen videos where the person rotates the jig parallel with the support when they get to the curve , and and ive also heard to lift the end of the knife upward and out. Clarification?
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Universal tool support is not square period
October 18, 2014, 02:14:29 AM
I just purchased a used supergrind and when I checked the universal tool support, it is not even close to being square. Im not talking about square to the stone. The horizontal support is not square to the vertical supports....is this normal? if not is it fixable or do I need to replace it?
Pages1