I will give it a go and see how I go.
Thanks for your suggestions.
Thanks for your suggestions.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Wood Carving / Re: Japanese bent gouge problems keeping square
May 01, 2010, 05:53:05 AM
There is about 10 cm protruding and the knuckle is adjusted on a bit over 2
#3
Wood Carving / Japanese bent gouge problems keeping square
April 29, 2010, 09:27:47 AM
On a recent trip to Japan I purchased a Japanese bent gouge for carving. When I tried putting the edge on it, I have been unable to keep the edge square using the SVd-185. One of the problems is getting the tool into the jig. The shank is tapered so I filed a flat spot on to it. It seemed fine but the end results say something is wrong. Any suggestions would be appreciated.
#4
Wood Carving / Re: Pfeil Chisels in the svd-185
November 18, 2009, 01:46:46 AM
Thanks for that! For some reason I didn't even think of removing the collar!
#5
Wood Carving / Pfeil Chisels in the svd-185
November 15, 2009, 04:49:28 AM
Hopefully I have that jig number right! Its the one for finger nail gouges or v-tools.
My quesiton has to do with using pfeil chisels in the jig, mine don't seem to fit because the shank is so small. Any suggestions on how I can get around this?
My quesiton has to do with using pfeil chisels in the jig, mine don't seem to fit because the shank is so small. Any suggestions on how I can get around this?
Pages1