I have a quick question on using TomekCalc. I would like to modify my honing process and increase the angle slightly. I would like to do this while using the BatchCalc sheet.
Is this possible?
Martin
I found the solution, apparently the column was hidden.
Quote from: MartinC on November 15, 2023, 03:57:30 AMI have a quick question on using TomekCalc. I would like to modify my honing process and increase the angle slightly. I would like to do this while using the BatchCalc sheet.
Is this possible?
Martin
Quote from: MartinC on November 15, 2023, 04:09:32 AMI found the solution, apparently the column was hidden.
I thought it was Column "S" "Angle Shift" (which isn't hidden). It says in the column notes that one reason for it is "Honing where a higher angle is required for the final burr removal."
I think you can also enter it on the "TormekCalc" page which will carry over onto the BatchCalc page (based on the "Wheel selection")... if you don't put anything in the Column "S".