News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Sharping Ultra Premium Steels

Started by brute, May 25, 2020, 02:39:59 PM

Previous topic - Next topic

brute

I have a question, anyone have experience sharping ultra premium steels? Like Maxamet, S110V, S90V, Elmax. Are CBM wheels good, or are Diamond wheels better?

Josu V

#1
Both kind of wheels are adequate for Premium Steels.

I have used both wheels for VGMax and S90V and I have obtained very good results.

(I understand where you write CBM you want write CBN)


Regards
Abusus non tollit usum

brute

Josu
My bad, typo error. Thanks for your reply.

RickKrung

If you have not already, you should avail yourself of Knife Grinder's work on sharpening all sorts of knives.  Best info I know of.

Deburring Book
Quality is like buying oats.  If you want nice, clean, fresh oats, you must pay a fair price. However, if you can be satisfied with oats that have already been through the horse, that comes at a lower price.