thanks for the tip! I will read the instructions and use the "locating" method if needed when I get it.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
General Tormek Questions / Re: Mounting horizontal base on a 2000 how-to?
October 26, 2022, 08:22:19 PM #2
General Tormek Questions / Spoke too soon!
September 29, 2022, 04:26:55 PM
So I did a Full internet search and found a Tormek live session on upgrades and they mentioned the mount comes with instructions on where to drill the holes.
Feel free to chime in with any other recommendations!
Feel free to chime in with any other recommendations!
#3
General Tormek Questions / Mounting horizontal base on a 2000 how-to?
September 29, 2022, 04:12:01 PM
New owner of an older model 2000. Wonderful community and resources here and doing my "research" and ordering some upgrades for this machine. I still have to register my machine but right now my big question is how to mount the horizontal base on this thing (and get it "square" to the wheel) I did a search but maybe my terms weren't accurate enough. It has a large sticker with instructions on the top where it would be mounted but no holes as far as I can tell.
Anyone have a link or can post the procedure for doing this accurately?
Anyone have a link or can post the procedure for doing this accurately?
Pages1