However, with the length of the shaft, the pressure on the main bearings of the shaft would be too great for me.
I hope that holds in the long term.
I hope that holds in the long term.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Knife Sharpening / Re: Leather strop
February 19, 2021, 01:56:03 PM
Has anyone here tried to pull the knife after the felt wheel still on an uncoated leather wheel? I get the knives very well sharp after the passage CBN ->SJ-250 -> felt wheel, but the last bit I achieve only with the bare leather belt.
My idea would be to replace the leather belt with a leather wheel, but use the smooth side here. Has anyone tried this by chance?
Greetings Markus
My idea would be to replace the leather belt with a leather wheel, but use the smooth side here. Has anyone tried this by chance?
Greetings Markus
Pages1