News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

planer blade jig

Started by bobl, April 04, 2015, 10:19:19 PM

Previous topic - Next topic

bobl

Hi,
can I use the planer blade jig to sharpen 8 inch - 10inch - and 12inch non serated / ham carving knives, or is this possible on the long jig for knives.
Thanks.
I await a reply with eagerness.
Cheers.
Bob
U.K.

Ken S

Welcome to the forum, Bobi.

I would use the long knife jig. The only difference between the relular and long knife jigs is the length of the clamping surfaces. The long knife jig has a clamping surface of 140 mm. It is especially designed for long, slender knives. The design lets you sharpen both sides of the knife without removing it from the jig. Leave the planer jig to planer and jointer blades.

Ken

bobl

Thanks a lot Ken. You have just saved me about 100 Quid.
Cheers.
Bob

Ken S

You are most welcome, Bobi.

To quote Scotty in one of the Star Trek movies, "The right tool for the right job."

Ken

bobl

cheers mate.
also got your email.
good to go.
please keep in touch.