I had a roughing gouge that was working pretty good and I decided to sharpen it with the tormek t4. I followed the marker method to sharpen. Now the gouge will not cut into the wood. I have checked and even used the settings P=75mm, SVS-50 open face and set the Universal Support with Hole A still the same result.
I can't figure what I've done wrong.
Any help appreciated.
On the SVS-50, I use 0° & projection of 55mm, combined with setting the USB using hole A on the TTS-100. This gives a 35° edge angle.
https://sharpeninghandbook.info/WW-SpindleRoughingGouge.html