News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - jgreen

Pages1
#1
General Tormek Questions / Dog Leg Chisels by Woodcraft
January 11, 2011, 11:16:06 PM
If my shop caught on fire, I would run back into the burning building and grab my Tormek! Now the serious question. I just purchased a set of dog leg chisels by Woodcraft and they don't seem to have enough "leg" to be able to clamp into the SVS-32 short tool jig. The jig indicates that the leg must be a minimum of 1 3/4" inch. The leg on these chisels are only 1 1/4".
Suggestions?
Jeff Green
#2
Hand Tool Woodworking / Sorby 3/8" corner chisel
January 10, 2008, 02:11:34 AM
How would I sharpen on my new T-7 a 3/8" corner chisel? The bevel is on the inside and since there are two opposing angles, which jig would I use and what angle approach to the grinding wheel would I use?
Pages1