News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu

Skew Bevel

Started by windknots, February 11, 2010, 05:23:21 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

windknots

February 11, 2010, 05:23:21 AM
What causes the two bevels on a skew to be different lengths?

Jeff Farris

#1
February 11, 2010, 06:15:12 AM
Grinding more on one side than the other.
Jeff Farris

windknots

#2
February 11, 2010, 06:48:45 PM
Jeff- Thanks for the prompt reply but I still have a question/problem.  I will try to describe it another way.

I'm using the SVS 50 jig and believe my wheel is parallel to the universal support. If I grind a skew that is 1/4 inch thick and look down from the top I find the cutting edge where the bevels intersect is not centered 1/8 inch from the left and right edge of the skew blade.
The cutting edge is always shifted to one side. The side with the shortest bevel.
Print
Go Up Pages1
User actions